In need of fast(er) programmer for new PIC33CK devices

Started by diebobo, Sep 26, 2021, 04:34 PM

Previous topic - Next topic

John Lawton

Hilarious, the Microchip SNAP programmer/debugger "...features a powerful 32-bit 300 MHz SAM E70 Arm® Cortex®-M7 based MCU for quicker debug iterations".

https://www.mouser.co.uk/pdfDocs/50002771B.pdf

How are the mighty fallen.

diebobo

Just a closure message, i've received the Northern Software programmer and it is FAST !.. Had some trouble setting it up but it now works with the commandline and Positron Studio. The test program ( blinky ) took like 20 secs orso on the Pickit 3, and now like 0.5 sec. So thanks a lot for that piece of info, very happy at the moment :)

charliecoutas

diebobo

Does it need the cumbersome MPLAB software or is the software interface small and simple?

Charlie

diebobo

It is completely standalone, so no need for MLAB software.. I doubt it can even work with MPLAB if u wished, but i only got it working for a few hours so total noob at this point with this programmer.

Check this link for impression of the GUI : https://www.northernsoftware.com/nsdsp/soft/prog/    I think it looks completely simple and clean.. And then there are a bunch of command line utils.

charliecoutas


John Lawton

Quote from: diebobo on Oct 15, 2021, 12:04 PMJust a closure message, i've received the Northern Software programmer and it is FAST !.. Had some trouble setting it up but it now works with the commandline and Positron Studio. The test program ( blinky ) took like 20 secs orso on the Pickit 3, and now like 0.5 sec. So thanks a lot for that piece of info, very happy at the moment :)

For many years I've used the meLabs U2 programmer, but if it won't support the latest devices I may have to change. I don't think you mentioned which Northern Software model you're using.
https://www.northernsoftware.com/nsdsp/cmp/hh.htm
Is it the NSDSP-2-X - which is the one I'd use as it supports HV programming?


John

diebobo

Quote from: John Lawton on Oct 15, 2021, 02:07 PMI don't think you mentioned which Northern Software model you're using.
https://www.northernsoftware.com/nsdsp/cmp/hh.htm
Is it the NSDSP-2-X - which is the one I'd use as it supports HV programming?

I did not mention it indeed.. I got the NSDSP-1-UX cause i do not see myself need the HV part of it. However i do see myself make mistakes with selecting the V settings and blow thing up ;)...  Nah, for some old projects i just use the Pickit2 if they don't support the LV programming.