ILI9341 Flosi and Les code

[Dompie]

The problem is not the ILI9341 but the library software that controls the ILI9341. The different font converters use different formats to store and administer the different characters in a font. The driver software for the ILI9341 uses a proprietary format that you can get from that driver software and then you can adjust a generated font to the need of the ILI9341 software driver. The biggest differences are in the first administrative blocks of data of a font and sometimes in the bit patterns of the characters themselves, but you can see that in the administrative information.
Ergo read the source of the routine that puts a character on the display and you can deduce the structure of the font.

Johan

[TimB]

I know this is an old thread but just started looking at using this driver how much work would it be to convert the routines to parallel?

Thanks

Tim

[top204]

Converting the ILI9341 driver to parallel will be very straightforward if looking at the library I created, because it is modular and the setup stays, nearly, the same. The graphics and font procedures would need very little change. The same for the SSD1306 display.

I always prefer a parallel interface becuase they are a lot faster that SPI on microcontrollers that do not have huge amounts of ooooommmmffff, and become outdated and harder to get within a few years of use.

[SeanG_65]

Try the "Wayback Machine", it might have something if you are really lucky