EEPROM inquiry

[JackB]

Hi JackB,

Plese let us know if the latest procedure modification helped to solve your question.

The modification seem to work fine as for reading and saving.

Thanks Trastikata, JonW

[JackB]

Good thinking

the only time the uC has to register and save the parameters are during calibration procedure and this is done
only when the sensor is installed or when the equipment is moved or a defective stepper motor is replace.

the time the metal detection is in effect it's only to stop the stepper motors, it does not use the calibration during normal operation

[JackB]

I will certaintly use this code.

many thanks Trastikata, and JonW