Problem with I2C ?

[See_Mos]

What am I doing wrong? 

The dummy test did not have an address byte following the control byte

[See_Mos]

My mistake

How do I delete this thread?

[streborc]

Is there perhaps a parameter missing from the command?

The command's context is:  I2COut SDA_Pin, SCL_Pin, Control, Addr, [Data_1, ... Data_n]

"Control" is the I2C device's I2C bus address, and Addr is the device's internal address where Data_1 thru Data_n get stored.

[streborc]

Our respective posts crossed path times -- never mind!

[See_Mos]

No worries, you are right.

Tiredness had set in and I was putting the register address inside the square bracket instead of directly after the device address.

[RGV250]

How do I delete this thread?

You can't, it is there for us all to see so when we make mistakes we can all feel better knowing we are not alone

Bob

[trastikata]

Just rename the original post to "Del" and the powers that be might grant you an audience.